![]() ![]() Woofer: 6 1/2” (162mm) polypropylene cone with a SantopreneTM surroundįrequency Response: 50Hz – 20 kHz +/- 3dB Tweeter: 1” (25mm) polyurethane dome, ferrofluid-cooled The cover plate will keep moisture from damaging the connections. If the speakers are all operating properly, refill the wire trenches and using the supplied screws, attach the wire termination cover plate to the connector panel on the bottom of the RK10W enclosure. After confirming that you have properly made all of the connections, turn your amplifier on and test the system with your favorite music.TOUCHING WIRES WILL CAUSE A SHORT-CIRCUIT WHICH COULD DAMAGE YOUR AMPLIFIER. IMPORTANT: BE SURE NOT TO LET ANY STRAY (+) AND (–) WIRES TOUCH EACH OTHER. IF EITHER CHANNEL IS CONNECTED INCORRECTLY LITTLE TO NO LOW FREQUENCY SOUND WILL BE PRODUCED. IT IS CRITICAL THAT THE POSITIVE AND NEGATIVE WIRES BE CONNECTED CORRECTLY FOR BOTH CHANNELS. ![]() NOTE: DOUBLE-CHECK THAT YOU HAVE CONNECTED ALL OF THE WIRES PROPERLY AMPLIFIER (+) TO SPEAKER (+) AMPLIFIER (–) TO SPEAKER (–) AT EACH OF THE CONNECTIONS. After making all the connections at the MR10W woofer, connect the speaker wires to your amplifier.Connect the wires from the MR6 satellites to the MR10W woofer (see figure 2.).NOTE: REGARDING THE 4 COLORED DIRECT BURIAL WIRE, THE RED (+) AND BLACK (-) ARE USED FOR THE RIGHT CHANNEL, AND THE WHITE (+) AND GREEN (-) ARE FOR THE LEFT CHANNEL. Connect those wires to the MR10W woofer (See Figure 2.) Run the appropriate gauge wire through the trench from your amplifier to the MR10W woofer.Be sure to check local codes for trenching limitations. You will need to trench from an area nearest your amplifier to the MR10W woofer and then from the woofer to the two MR6 satellites. Dig a 4” to 5” trench to run the speaker wires in.Place the two rock satellites and the rock woofer in their approximate final locations.USING INDIVIDUAL CONDUCTORS WITH DIFFERENT COLORS MAKES IT EASY TO IDENTIFY AND ACCESS BOTH AMPLIFIER CHANNELS. IT IS IMPORTANT TO USE ONLY DIRECT BURIAL WIRE TO MAINTAIN LONG-TERM SIGNAL INTEGRITY AND PREVENT CORROSION. NOTE: 14/4 REFERS TO 14 GAUGE, 4-CONDUCTOR WIRE. Types of Wire WIRE GAUGE CHART Wire Gauge DISTANCE 18 Gauge Up to 100 feet (30 meters) 16 Gauge Up to 150 feet (45 meters) 14 Gauge Up to 250 feet (80 meters) THIS DRAMATICALLY IMPROVES THE SATELLITE SPEAKER’S POWER HANDLING. NOTE: THE MR10W WOOFER HAS BUILT-IN LOWPASS AND HIGH-PASS FILTERS THAT DIRECT THE BASS FREQUENCIES TO THE WOOFER AND THE REST OF THE SOUND TO YOUR SATELLITE SPEAKERS. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |